INSTA-CURE+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. The thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+™ should also be used.
The SUPER-GOLD+™ do not attack white foam; therefore, it can be used in the building of foam core wings and the assembly and repair of plastic and foam ARF’s. They will not fog clear plastic. SUPER-GOLD+™ is ideal for attaching clear canopies. There are no fumes that irritate the nose and eyes.
INSTA-FLEX+™ is clear rubber toughened, it has similar qualities to IC-2000™, but can be used where you do not want the adhesive to be seen. The black colour carbon component of IC-2000™ contributes to it's unsurpassed strength. Since INSTA-FLEX+™ has this carbon removed, it's strength is reduced, but still superior to standard CA's.
If parts are bonded incorrectly a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics.